Peak |
The PeakSearchingByCwt type exposes the following members.
Properties| Name | Description | |
|---|---|---|
 | MaximalNumberOfPeaks | Gets/sets a limit for the number of peaks returned. If set, only the peaks with the highest amplitudes are included (up to this number). |
| MinimalRelativeGaussianAmplitude | Gets the minimal relative Gaussian amplitude (relative to the maximum Gaussian amplitude) that a peak must have to be included in the result. The default value is 0.005 (0.5%). |
| MinimalRidgeLengthInOctaves | Gets the minimal ridge length (in octaves) that a ridge must have to be considered an indication of a peak. |
| MinimalSignalToNoiseRatio | Gets the minimal signal-to-noise ratio a peak must have to be included in the result. |
| MinimalWidthOfRidgeMaximumInOctaves | Gets the minimal width (in octaves) of the ridge maximum. Along a ridge, the maximum CWT coefficient indicates the best match of the peak with the wavelet; the peak width can be derived from that location. The default value is 2 octaves (1 to the left, 1 to the right). |
| NumberOfPointsPerOctave | The width of the wavelets is varied logarithmically. The value gives the number of points per octave of width variation (octave = factor of two). The default value is 8. |
| PeakEnhancement | Gets/sets the peak enhancement method (default is PeakEnhancementNone, i.e. no peak enhancement). |
| Wavelet | Gets the wavelet function used for transformation. Default is WaveletRicker. |
See Also