Peak |
The PeakFittingByIncrementalPeakAddition type exposes the following members.
Properties| Name | Description | |
|---|---|---|
 | FitFunction | Gets /sets the fit function to use. |
| FitWidthScalingFactor | Gets / sets the scaling factor of the fit width. This value, when set, determines the width around a peak, that is used to calculate the parameter errors of that peak (the width around the peak is calculated using this number times the FWHM value of the peak). |
| IsMinimalFWHMValueInXUnits | |
| MaximumNumberOfPeaks | |
| MinimalFWHMValue | |
| MinimalRelativeHeight | Gets/sets the minimal relative height. The addition of new peaks is stopped if the fitting residual falls below this value. |
| MinimalSignalToNoiseRatio | Gets/sets the minimal signal-to-noise ratio. The addition of new peaks is stopped if the ratio of the highest remaining peak with respect to the noise level falls below this value. |
| OrderOfBaselinePolynomial | Gets or sets the order of the polynomial that is used for the baseline. |
| PrunePeaksSumChiSquareFactor | Gets/inits a factor that will prune peaks based on their contribution to the sum of chi square. |
See Also