Runge |
The RungeKuttaExplicitBase type exposes the following members.
Name | Description | |
---|---|---|
![]() | A | Central coefficients of the Runge-Kutta scheme. See [1], page 135. |
![]() | A_Interpolation | Gets additional central coefficients of the Runge-Kutta scheme that are used for dense output (interpolation). |
![]() | AbsoluteTolerance | Gets or sets the absolute tolerance. |
![]() | AbsoluteTolerances | Gets or sets the absolute tolerances. The length of the array must either be 1 (tolerances for all y equal), or of length N. |
![]() | BH | High order bottom side coefficients of the Runge-Kutta scheme. |
![]() | BHML | Differences between high order and low order bottom side coefficients of the Runge-Kutta scheme. |
![]() | C | Left side coefficients of the Runge-Kutta scheme. |
![]() | C_Interpolation | Gets additional left side coefficients of the Runge-Kutta scheme (x-partitions) that are used for dense output (interpolation). |
![]() | InterpolationCoefficients | The interpolation coefficients aij. Note that zero to third order interpolation is using y and slope of x_previous and x_current. Thus in this array we only need the coefficients for 4th order (and higher) interpolation. |
![]() | NewCoreNotInitializedException | Creates a new exception that indicates that the core is not initialized. |
![]() | NumberOfAdditionalStagesForDenseOutput | Gets the number of stages of additional stages needed for dense output. |
![]() | NumberOfStages | Gets the number of stages for the main process (stages needed for dense output not included). |
![]() | Order | Gets the order of the method (the highest of the pair). |
![]() | RelativeTolerance | Gets or sets the relative tolerance. |
![]() | RelativeTolerances | Gets or sets the relative tolerances. The length of the array must either be 1 (tolerances for all y equal), or of length N. |
![]() | StiffnessDetectionEveryNumberOfSteps | Gets or sets the number of successful steps between test for stiffness. Setting this value to 0 disables stiffness detection. The default value is 0. |
![]() | StiffnessDetectionThresholdValue | Sets the stiffness detection threshold value. |